Jenn-Air KitchenAid KBSD708M S00 Series Technical Manual page 34

COMPONENT ACCESS (CONT.)
5. Locate the fill tube from behind the refrigerator and remove
two (2) 1/4" hex head screws.
6. Pull fill tube and water line out of refrigerator.
Removing the Fill Tube (Dispensing
Units Only)
1. Complete the steps 1-4
Assembly (Dispensing Units Only).
2. Complete the steps 1-3
Water Inlet and Isolation Valves.
3. Remove the water line from the ice maker water inlet valve
by removing the lock ring from the John Guest fitting first.
4-14 JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
n
from section Removing the Ice Maker
from section Accessing the Ice Maker
4. Remove center back panel by removing six (6) 1/4" hex head
screws.
5. Pull water line out of conduit.
6. Complete the steps 1-3
Decorative Cover.
7. Complete the steps 1-2
Access panel.
8. Complete the steps 1-2
Cover.
from section Removing the Front
from section Removing the Front
from section Removing the Unit Top