Jenn-Air KitchenAid KBSD708M S00 Series Technical Manual page 32

COMPONENT ACCESS (CONT.)
Removing the Evaporator Thermistor
1. Complete the steps 1-3
Evaporator Cover.
2. Complete the steps 1-6
Evaporator Fan.
3. The thermistor is mounted on the left side of the evaporator
on the outlet line. Positioning is critical so when replacing the
thermistor, mount in the same position.
NOTE: Servicing this thermistor will require a thermistor kit
which has components available to splice into the existing
thermistor harness.
Access to Evaporator
1. Complete the steps 1-3
Evaporator Cover.
2. Complete the steps 1-6
Evaporator Fan.
3. Now evaporator can be accessed.
A. Defrost Heater Wire Connections
B. Evaporator and Heater Assembly
4-12 JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
n
from section Removing the
from section Removing the
from section Removing the
from section Removing the
Removing the Ice Maker Assembly
(Non-dispensing Units Only)
1. Loosen two (2) 1/4" hex head screws on top of the ice maker.
2. Remove one (1) 1/4" hex head screw from the ice maker
mounting bracket.
A. Unit Top Cover Right side
3. Disconnect the electrical connector and then remove the Ice
Maker.
A. Defrost Heater Wire Connections
B. Evaporator And Heater Assembly