Table of Contents
Advertisement
Removing the Unit Top Cover
1. Remove four (4) 1/4" screws from the right side and six (6)
1/4" screws from the left side.
Figure - Unit Top Cover Left Side
Figure - Unit Top Cover Right Side
2. Lift the Unit Top Cover off.
Removing the Control Board
1. Complete the steps
1-3
Decorative Cover.
2. Complete the steps
1-2
Access panel.
from section Removing the Front
from section Removing the Front
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
COMPONENT ACCESS (CONT.)
3. Remove two (2) 1/4" hex head screws from the power switch
and humidity sensor mounting bracket, then remove the
bracket.
A. ON/OFF Switch
B. Humidity Sensor
4. Disconnect all the wires.
5. Push the release tabs on the left and top side of the board
and slide board out of the mounting brackets on the right
side.
4-3
n
Advertisement
Table of Contents
