Electrical - Hussmann DSF Installation And Operation Manual

Electrical

Standard Case Wire Color Code
Color Decsription
Ground
Anti-Sweat
Lights
Receptacles
T-Stat/Solenoid 230VAC
T-Stat/Solenoid 115VAC
T-Stat/Solenoid 24VAC
Fan Motors
Blue Condensing Unit
Use Copper Conductors Only
430-01-0338 R101003
CASE MUST BE GROUNDED
NOTE: Refer to label affixed to case to determine the actual
configuration as checked in the "TYPE INSTALLED" boxes.
Standard lighting for all refrigerated models will be full length
LED Lights located within the case at the top.
Electrical Components Location
Electrical components (if applicable) will be located in the lower rear raceway of the DSF merchandiser.
1. Remove free-floating splashguard away from case.
2. Elect. / Refer. panels are designed with simple slide in and rest designs. Lift conduit panels up and away from case to
gain access to conduits.
Field Wiring and Serial Plate Amperage
Field Wiring must be sized for component amperes printed
on the serial plate. Actual ampere draw may be less
Color
than specified. Field wiring from the refrigeration control
Green
panel to the merchandisers is required for refrigeration
Purple
thermostats. Case amperes are listed on the wiring
Orange
diagram, but always check the serial plate.
Yellow
Red/Black
White/Black
Red/White
Brown
ELECT/REF CONDUIT
(IF APPLICABLE)
23
DANGER
BEFORE SERVICING
ALWAYS DISCONNECT ELECTRICAL
POWER AT THE MAIN DISCONNECT
WHEN SERVICING OR REPLACING ANY
ELECTRICAL COMPONENT.
This includes (but not limited to) Fans, Heaters
Thermostats, and Lights.
PLUMBING COMPONENTS