EverFocus ENQ2200 User Manual page 31

All manuals and user guides at all-guides.com
This example describes how to set the camera to trigger alarm output as well as to
upload image to FTP when someone presses Manual Trigger button:
1. Click button in Event page.
2. Enter an event name for the event, e.g. Event 1
3. Select "Manual Trigger" as event type.
4. Ctrl + click to multi-select notification types. Select "Trigger Alarm Output" and
"Upload to FTP" as notification types.
5. Check "Enable Pre-alarm Buffer" and "Enable Post-alarm Buffer".
Note:
1. If "Pre-alarm Buffer" is active, the camera will provide up to 120 sec
pre-alarm record additional to the event record.
2. If "Post-Alarm Buffer" is active, the camera will provide up to 1
post-alarm record to the event record.
3. If "Enable Re-Trigger" is active, the alarm
case of a repeating event during the previous alarm period.
Press Apply to a pply the setting changes or Can
c ange. h
timeout duration will be restarted in
cel to cancel without saving the
31
EQN2200/2201
20 sec