Installing Oms And Usb Midi Driver On Macintosh; Connecting The Sk-500 And The Macintosh - Roland Sound Canvas SK-500 Owner's Manual

Installing OMS and USB MIDI Driver on Macintosh

Connecting the SK-500 and the Macintosh

You can easily connect the SK-500's USB connector and a Macintosh's USB
port with a single USB cable. You will need the following:
• The SK-500
• USB cable
• AC adaptor
Referring to the connection diagram below, use the following procedure to
connect the devices.
1
Make sure that power to the Macintosh and all connected
peripheral devices is turned off.
2
Set the SK-500's computer switch to "USB." Connect the
included AC Adaptor.
(Leave the [POWER] switch in the OFF position.)
fig.mac-usb-e
Set the computer switch to
"USB."
USB Cable
3
Connect the USB cable to the Macintosh's USB port. Proceed
by connecting the other end of the cable to the SK-500's USB
connector.
4
After turning on the power for the connected peripheral
devices, turn on the Macintosh's power.
44
Always be sure to turn off the
power whenever connecting
another device or instrument,
or when changing the computer
switch setting.
MIDI OUT
To USB Connector
Confirm the connector type, then
fit the connectors together.
To USB Port
* Refer to the owner's manual
for your computer to confirm
the location of the USB
connector.
Macintosh
SK-500
The computer switch
AC Adaptor
settings go into effect when
the power is turned on. If
you have changed the
settings with the power on,
then turn the power off for
a moment, and then back
on again.