Vax TBT3V1T1 Manual page 8

Getting started
Fixing the wall bracket
Fully assemble
the slim vac.
Using a pencil, make
a mark to show the
required position of
the wall bracket. Lift
to remove the slim vac
from the wall bracket.
Line up the wall bracket with the back of the handheld.
Slot the bracket into the handheld and push upwards
to lock into place.
Align the bracket back
to the wall and make an
additional 3 small marks
for each screw.
Use the screws and wall
plugs to secure the wall
bracket to the wall.
Choose a location for the
slim vac to be stored,
preferably near to a
mains supply. Stand the
slim vac in the upright
position against the wall,
with the Powered Head
flat on the floor.
Store the slim vac on the
wall bracket by lifting the
slim vac slightly above
the bracket and sliding
the back of the handheld
down and onto the
bracket. Always ensure
the slim vac is securely
locked into place.