Using Your Machine - Vax TBT3V1T1 Manual

NOTE: The slim vac has a constantly rotating brushbar when activated. Never leave the slim vac in one spot for an
extended period of time as this may damage the floor surface. Always turn the brushbar off when cleaning hard
floors. The brushbar should be ON for carpets and OFF for hard floors. To prevent any damage being sustained
test on an inconspicuous area of the flooring.
IMPORTANT: If the brushbar has been obstructed, the motor protection sensor may have been activated.
The brushbar will stop and the light on the Powered Head will illuminate red. To reset, remove the Powered Head
from the reach wand/handheld and clear any obstruction. Wait 1 minute before refitting the Powered Head, switch
the slim vac on and press the brushbar on/off button.
Using the cordless slim vac
Place your foot on the Powered Head and pull
the handle backwards to recline.
To switch the brushbar on, press the brushbar on/off
button. The light on the Powered Head and the brushbar
on/off light will illuminate to indicate the brushbar is
on and the brushbar will constantly spin. To switch the
brushbar off press the brushbar button again.
The slim vac will always start with the brushbar off.
NOTE: Constant use of the boost mode and brushbar feature will reduce the battery run time.

Using your machine

To switch the slim vac
on, press the on/off
button located on the
back of the handle. The
battery level indicator
light on the handle and
battery charging light will
illuminate white.
When the slim vac is
switched on, the boost
on/off button will also
illuminate, confirming that
the boost mode is 'On'.
The slim vac will always
start in boost mode.
Pressing the boost button
will deactivate/activate the
boost mode.
Boost mode increases
suction for particularly
dirty areas that require
additional cleaning.