Vax TBT3V1T1 Manual page 18

Let's talk technical
Removing and replacing the brushbar
A
On the base of the
floorhead, find letter A
to indicate the side of
the brushbar cover that
needs to be removed.
To re-fit the brushbar, firstly push the brushbar onto
the brushbar cover, then slide the brushbar and cover
back into the brushbar housing. Make sure the end of
the brushbar sits securely in place. Refit and tighten
the screws to secure.
Removing and replacing the belt
B
On the base of the
floorhead, find letter B
to indicate the side of
the belt cap that needs
to be removed.
Using a cross head
screwdriver, unscrew the
three screws and remove
the brushbar cover.
Using a cross head
screwdriver, unscrew the
three screws and remove
the cover.
Slide the brushbar out
from the brushbar housing.
If the belt is broken,
remove this and slide the
new belt onto the cogs.
Clear any threads or
hair from around the
brushbar and any dirt/
debris inside the housing
of the Powered Head.
Refit the belt cover and
tighten the screws to
secure.