Vax TBT3V1T1 Manual page 12

Using your machine
Using the slim vac reach wand
The reach wand can be used for hard to reach places.
Press the Powered Head/
accessory release clip
and pull to remove the
Powered Head from the
reach wand.
To switch the slim vac on,
press the on/off button
located on the back of
the handle.
NOTE: Constant use of the boost mode will reduce the battery run time.
The reach wand can be used for hard to reach places
and at different heights for above floor cleaning.
Choose an accessory
(pictures illustrated
depending on model).
When the slim vac is switched on, the boost on/off
button will also illuminate, confirming that the boost
mode is 'On'. The slim vac will always start in boost
mode. Pressing the boost button will deactivate/activate
the boost mode.
Push the chosen
accessory into the
reach wand until it
clicks into place.
Boost mode increases
suction for particularly
dirty areas that require
additional cleaning.
The slim vac is not free standing and in between uses
must always be placed in the wall bracket, or laid flat on
the floor in a suitable location, so that it does not become
a trip hazard or can be stepped on.