Let's Talk Technical - Vax TBT3V1T1 Manual

Removing blockages from the handheld and reach wand
Press the handheld
release button and
remove the reach wand.
Check and clear any
dirt and debris from this
connection point.
Removing blockages from the Powered Head
IMPORTANT: If the brushbar has been obstructed, the motor protection sensor may have been activated.
The brushbar will stop and the light on the Powered Head will illuminate red. To reset, remove the Powered Head
from the reach wand/handheld and clear any obstruction. Wait 1 minute before refitting the Powered Head, switch
the slim vac on and press the brushbar on/off button.
Press the Powered Head/
accessory release clip
and pull to remove the
Powered Head from the
reach wand.
To test for a blockage in the reach wand, drop a small
ball of paper into the wand. The paper will drop through
if the wand is clear. Use a broom handle or similar blunt
object to remove any blockage.
Check the Powered Head
for any blockages and use
a blunt object to remove
the blockage.

Let's talk technical

Using scissors, remove
any threads or hair from
around the brushbar and
clear any dirt or debris
from the Powered Head.