Rimage Amigo II Hardware Manual page 3

Replace a Recorder on a Rimage Producer II
b. Pull the recorder out the front of the Producer
II.
Install the Recorder
1. Slide the replacement recorder into the front of the
Producer II.
2. Connect the cables to the back of the recorder.
•
FireWire cable (Qty. 1 or 2, depending on recorder position)
•
Power cable
Important! Be sure to match the original configuration of the cables. The bottom recorder is connected to the
FireWire cable from the back cover.
Autostar II or Protégé II
3. Install the back panel. If necessary, refer to the photos in step 1 of the Remove the Recorder section on page 1.
a. Raise or position the back panel.
b. Insert and tighten the Torx T10 screws (Qty. Amigo II = 4 or 6, Autostar II/Protégé II = 4).
112043_D
Autostar II™, Protégé II™ or Amigo II™
Power Cable
FireWire
Cables
© 2008, Rimage Corporation
Amigo II
3