Advertisement
OPERATIONAL INSTRUCTIONS
PEDAL STRAP ADJUSTMENT
If you feel it is more comfortable for your workout, you can attach the PEDAL STRAP(20) to the lower
position in the PEDAL CAP(19) as shown in illustration 1 below. Run the PEDAL STRAP(20) through the
opening from the bottom of the PEDAL CAP(19). Pull the PEDAL STRAP(20) to make the Knot against the
bottom of the PEDAL CAP(19). Run the PEDAL STRAP(20) through the opening in the PEDAL CAP(19)
on the other side from the top as shown in the illustration 1, then make the end of the PEDAL STRAP(20)
go up to attach onto the upper part of the PEDAL STRAP(20) with the Hook & Loop Pad.
Attach the end of the PEDAL STRAP(20) to different position with the Hook & Loop Pad to adjust the length.
Refer to illustration 2.
1.
2.
Hook & Loop Pad
Knot
End of Pedal Strap
Hook & Loop Pad
HEART RATE TRANSMITTER
The Stamina® 1130 Magnetic Rowing Machine can measure how hard you are exercising by monitoring
your heart rate with the HEART RATE TRANSMITTER(103). Your heart rate reading gives you a snapshot
of how hard your heart is working at that point in your workout by measuring the number of heart beats
per minute.
The HEART RATE TRANSMITTER(103) worn around your chest sends your heart rate information to
a receiver inside the COMPUTER(35) so your heart rate is tracked while you exercise. This is the most
reliable way to measure your heart rate to make sure you are exercising within your target heart rate zone
so you get the most out of your workout time.
Using the Heart Rate Transmitter Chest Strap
The HEART RATE TRANSMITTER(103) worn around the chest is powered by a BUTTON BATTERY
(CR2032)(107) located in the center of the strap. Two electrodes on either side of the battery monitor
your heartbeat, and an adjustable ELASTIC STRAP(104) holds the transmitter in place. The receiver built
into the Stamina® 1130 Magnetic Rowing Machine picks up your heart rate from the HEART RATE
TRANSMITTER(103) and displays it on the monitor during your workout.
11
Advertisement
