Configuration
IEEE 1394 Configuration
Use this procedure to configure the
printer for use in an IEEE 1394 envi-
ronment. The following table shows
the control panel settings and their
default values. These items appear in
the "Host Interface" menu.
Setting Name
DHCP
IP Address1394
Subnet Mask1394
IP over 1394
SCSI print
5
Bidi-SCSI print
Note
❒ If DHCP is in use, "IP Address1394"
and "Subnet Mask1394" are auto-
matically set.
IP over 1394
A
Press the {Menu} key.
"Menu" appears on the display.
72
Value
On
011.022.033.044
000.000.000.000
Active
Active
Active
AET005S
B
Press the {U} or {T} key to dis-
play "Host Interface" menu, and
then press the {# Enter} key.
Menu:
Host Interface
The interface setting menu ap-
pears.
C
Press the {U} or {T} key to dis-
play "IEEE 1394 Setup", and then
press the {# Enter} key.
The IEEE 1394 setting menu ap-
pears.
D
Press the {U} or {T} key to dis-
play "IP over 1394", and then
press the {# Enter} key.
The IP over 1394 setting menu ap-
pears.
E
Press the {U} or {T} key to select
either "Active" or "Not Active",
and then press the {# Enter} key.
IP over 1394:
*Active
After the settings are made, about
two seconds later, the screen re-
turns to the IEEE 1394 setting
menu.
F
Assign the IP address to the print-
er. Press the {U} or {T} key to dis-
play "IP Address1394", and then
press the {# Enter} key.
The current IP address appears on
the display.