Table of Contents
Advertisement
16. IMAGE QUALITY PROBLEM
16.2.31
Printer 4-color: void areas, white spots
A. Typical faulty images
B. Troubleshooting procedure
Step
Section
1
Image check
2
3
Transfer belt unit Fingerprints, oil, or other foreign
4
5
Transfer roller
unit
6
7
Paper path
8
9
254
Void areas
Check item
There are void areas at the front
side or high density section.
There are void areas in the trailing
edge.
matter is evident on the transfer
belt.
Transfer belt is dirty or scratched.
Transfer roller is dirty or scratched.
Charge neutralizing needle is not
separated and ground terminal is
connected properly.
There is foreign matter on paper
path.
Pre-image transfer guide plate is
damaged or dirty.
The problem has been eliminated
through the checks of steps up to 8.
Field Service Ver. 1.1 Jun. 2010
White spots
Result
Action
YES
See P.252
YES Perform [2nd Image transfer Cur-
rent] of [Printer Adjustment]
under Service Mode.
YES Clean it with the tender cloth or
paper which is dusted with the
toner.
YES Clean dirty belt with a soft cloth.
Change transfer belt unit if belt is
damaged.
YES Change 2nd image transfer roller
unit.
NO
Correct or change.
YES Remove foreign matter.
YES Clean or change.
NO
Change transfer belt unit.
A02EF4C523DA
Advertisement
Table of Contents
