Table of Contents
Advertisement
118
7.2 Resetting the System
There are three types of reset available for the HSB Series Chartplotter:
• Factory Reset: This resets all values back to their original factory
settings.
CAUTION:
The factory reset clears the Waypoint and Route databases.
• Power-On Reset: When you turn the display off and on again, the
screen reverts to the chart picture with all windows cleared.
• Chart Picture Reset: Press and hold the DISPLAY key for two
seconds to return the screen to the full-screen chart picture with all
windows and grouped data boxes cleared.
At power-on, the last-used values are retained for all the options, except
for those listed in the following table which are reset to the factory default
each time.
Item
Heading Mode
Alarm
Zoom
Windows
Contrast Level
Backlight Level
To perform a factory reset:
1. Press MENU.
2. Press the SYSTEM SET UP soft key to display the System Set Up
page (see Chapter 5 for details).
3 Press and hold MENU for 5 seconds.
A countdown timer is displayed. If you release the MENU key before
the timer reaches zero, the reset is not performed.
When the reset request has been accepted, the chartplotter re-
starts.
The factory default settings are listed in Chapter 5.
Power-on setting
North Up
ON, with last-used value
OFF
OFF
Within 30-70% range, if last-used value outside this range
ON at 42% if previously selected
HSB Series Chartplotter
Advertisement
Table of Contents
