Resetting The System; Problem Solving - Raymarine Raychart 425 Owner's Handbook Manual

6-2
the installation instructions, to enable you to ensure minimum interaction
between different items of equipment, ie. ensure optimum
Electromagnetic Compatibility (EMC).
Always report any EMC-related problem to your nearest Raymarine
dealer. We use such information to improve our quality standards.
In some installations, it may not be possible to prevent the equipment
from being affected by external influences. In general this will not
damage the equipment but it can lead to spurious resetting action, or
momentarily may result in faulty operation.

6.2 Resetting the System

Two types of reset are available for the Chartplotter:
•
•
Note: Take care - factory reset clears all Waypoint and Route databases.
➤
To perform a factory reset:
1. Power off the unit.
2. Press and hold CLEAR whilst powering up until <Erase backup pro-
3. Either press CLEAR to abort Factory Reset and resume normal
4. Press ENTER again; the unit restarts as for a first time Power Up with
Note: The factory default settings are listed in Chapter 4.

6.3 Problem Solving

Prior to packing and shipping, all Raymarine products are subjected to
comprehensive test and quality assurance programmes. However, if this
unit should develop a fault, please refer to the following table to identify
the most likely cause and the corrective action required to restore normal
operation.
If you still have a problem after referring to the table, contact your local
dealer, national distributor or Raymarine Techncial Services for further
advice.
Always quote the product serial number.
Power-On Reset: When you turn the display unit off, then on again,
the screen reverts to the chart display with all windows cleared.
Factory Reset: This resets all values back to their original factory
settings.
cedure> is displayed.
Power-Up or press ENTER to continue Factory Reset.
all values reset to their original factory settings
Raychart 425 Chartplotter