Positioning The Cooker; Unpacking The Cooker; Moving The Cooker - Rangemaster Toledo XT Electric Users Manual & Installation

Positioning the Cooker

The diagrams below show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above,
any adjacent work surface. Above hotplate level a gap
of 75mm should be left between each side of the cooker
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal
or ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the
top of the hotplate and a horizontal combustible surface.
*Any cooker hood should be installed in accordance with
the hood man u fac tur er's instructions.
Surfaces of furniture and walls at the sides and rear of
the appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration.
We cannot accept responsibility for damage caused
by normal use of the cooker to any material that de-
laminates or discolours at temperatures less than 65°C
above room temperature.
For safety reasons curtains must not be fi tted
im me di ate ly behind the cooker.
We recommend a gap of 1110mm between units to
allow for moving the cooker. Do not box the cooker in; it
must still be possible to move the cooker in and out for
cleaning and servicing.
INSTALLATION
Check the ap pli ance is electrically safe when you have fi nished.
Checking the parts
Allen key
Handygrill rack
3 fl at oven shelves and 1 drop
shelf
A clearance of 130mm is required if the cooker is near a
corner of the kitchen to allow the oven doors to open.
The actual opening of the doors is slightly less but this
allows for some protection of your hand as you open the
door.
Plan view
A clearance of 130mm each side is required to allow for oven
door opening.

Unpacking the Cooker

Do not take any packaging off the cooker until it is
directly in front of the place it is to be installed (unless it
will not fi t through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, leaving the cooker standing on the base
packaging. See the loose unpacking sheet.

Moving the Cooker

The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the fl oor covering is fi rmly fi xed, or removed
to prevent it being disturbed when moving the cooker
around. You will need the levelling tool.
23
Levelling tool
Handygrill pan / Meat tin
Plinth