Rangemaster Toledo XT Electric Users Manual & Installation page 28

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity servicing. Check appliance is safe when you have finished.
13. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep, and
screw in or out as required until required fi t is obtained.
Retighten locking nut.
14. To Change Oven Door Seal
Open oven door. The seal is held in place by small hooks
on the rear face. At the corner pull seal diagonally away
from the door centre until that hook is released. Proceed
to the next hook and release it in a similar way, and so
on. Use force if the hooks are stiff , as the old seal will be
discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
15. To Remove Oven Inner Back
Open the oven door. Remove oven furniture. For the LH
oven unscrew the 2 thermostat phial fi xing screws.
Remove the fi xings that secure the inner back to the
oven rear.
Lift the removable panel away. Re-assemble in reverse
order. Ensure that the retaining fi xings are fully
tightened. For the LH oven unscrew the 2 thermostat
phial fi xing screws. Remove the screws that secure the
inner back to the oven rear. Lift the removable panel
away. Re-assemble in reverse order. Ensure that the
retaining fi xings are fully tightened.
16. To Replace an Oven Fan
Disconnect from the electricity supply.
Pull cooker forward to gain access to the rear. Remove
screws securing the electric cover to the back sheet and
remove cover. Disconnect the 3 terminals connected to
the fan noting their position. Remove oven inner back
(see 15).
Hold the fan blade and remove the centre nut (left hand
thread) 2 brass washers, fan blade and circlip. Unscrew
fan retaining nuts and washers (3 off each) and lift the
fan away from the rear of the cooker. Fit new fan and
reassemble in reverse order. Check operation of oven.
17. To Remove an Oven fan Element
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at the
rear of the appliance. Remove the fi xings that secure
the cover and lift it clear. Undo the terminal connections
noting their positions. Remove the inner back as
detailed in Section 22. Remove the fi xings that secure
the element within the oven and lift the element away
carefully. Fit the replacement element and re-assemble
parts in reverse order. Check that the oven operates
correctly.
28