Errors What To Do - Asko TD85.C18X User Manual

Errors what to do?
Disturbances from the environment (e.g. the power grid) may result in various error reports (see
Troubleshooting table). In such case:
• Switch off the appliance, wait for 1 minute, switch the appliance back on, and repeat the drying
program.
• If the error persists, call an authorized service center.
• You will be able to solve most of the problems in appliance operation by yourself (see below
Troubleshooting table ).
• Repairs may only be carried out by an adequately trained person.
• Repair or any warranty claim resulting from incorrect connection or use of the dryer shall not be
covered by the warranty. In such cases, the costs of repair shall be charged to the user.
INFORMATION!
The warranty does not cover the errors or failures resulting from disturbances from the environment
(lightning strike, power grid failures, natural disasters etc.).
Problem/error Cause
The machine
•
will not start.
•
There is
•
voltage in the
outlet, but the
drum does
•
not spin ...
The dryer
does not
•
work.
•
The machine
•
stops operat-
ing com-
pletely during
a program.
38
The main switch is not switched
on.
There is no voltage in the power
outlet.
Program was not started in ac-
cordance with the instructions.
Door might be open.
The condensate tank is full (only
applies to condensation dryer
and the dryer with a heat pump).
Delayed start might be activated.
The door net filter may be
clogged. As a result, the temper-
ature in the dryer rises, which in
turn causes overheating, and the
dryer switches off.
What to do?
• Check whether the main switch is on.
• Check the fuse.
• Check if the power cord plug is correctly
inserted into the power outlet.
• Re-read the instructions for use again.
• Check if the door is closed properly.
• Empty the condensate tank (see section
"CLEANING AND MAINTENANCE")
(only applies to condensation dryer and
the dryer with a heat pump).
• To cancel the Delayed Start option,
press 5 the Skip button.
• Clean the door net filter (see chapter
"CLEANING AND MAINTENANCE").
• Wait for the machine to cool down, and
try running it again. If the dryer still fails
to start, call service centre.