Table of Contents
Advertisement
Quick Links
Dear Customer,
Read these instructions carefully and completely before you install the
machine. The installation should be carried out by a qualifi ed person who
is familiar with all local codes and ordinances for electrical and plumbing
connections. See also the general Safety Instructions in the Use & Care
Guide.
Cosmetic damage must be reported to the ASKO dealer within fi ve
days from the date of purchase. As soon as you unpack the machine,
thoroughly check it for cosmetic damage.
Installation instructions for vented tumble dryer
DOMESTIC
Advertisement
Table of Contents
Related Manuals for Asko TD70.1 SPO
Summary of Contents for Asko TD70.1 SPO
- Page 1 See also the general Safety Instructions in the Use & Care Guide. Cosmetic damage must be reported to the ASKO dealer within fi ve days from the date of purchase. As soon as you unpack the machine, thoroughly check it for cosmetic damage.
-
Page 2: Positioning The Tumble Dryer
The tumble dryer can be placed on top of an To reduce the risk of of severe injury or death, ASKO washing machine. Use the two foot cups follow all installation instructions. found in the document bag included with the... - Page 3 Installation instructions 3. Secure the anti-tip device using the screws 6. Push the tumble dryer in under the metal as shown in the picture. brackets. At the same time keep the front edge raised by 7/16" (10mm) to 7/8" (20mm) . 7.
-
Page 4: Install In A Closet
Installation instructions Built-in Install in a closet ASKO's front panel controls make it possible to install the washers and dryers in a closet. Make sure there is a ½” (12mm) minimum clearance between units and cabinet or wall. To ensure proper ventilation, we recommend louvered doors. -
Page 5: Air Exhaust
Make any necessary bends as gentle as possible. Asko dryers have a "T-style" Vent exhaust vent that allows you to NOTE! - Page 6 Installation instructions Connecting the exhaust duct to the Connecting to a ventilation duct Left or Right Side Outlet You will need a UL-CSA-approved, 4-inch To connect the exhaust duct to the left or right ridged metal exhaust duct. If a fl exible duct is side outlet, follow the steps below: used, it must comply with the Outline for Clothes 1.
- Page 7 Installation instructions To connect the exhaust duct to a ventilation outlet, follow the steps NOTE! below: 1. Connect the exhaust duct to a ventilation Avoid: exhaust fi tting or to a discharge through the • very long exhausting systems wall. •...
-
Page 8: Electrical Installation
Electric models of the dryer are manufactured the washing machine or an equivalent. for a 3-wire connection system. The dryer frame ASKO washers rated 208–240 V have two is grounded by a link to the neutral conductor internal fuses of 15 A each. - Page 9 Installation instructions Connecting a 3-wire Power Cord 4. Loosen or remove center terminal block screw. WARNING! Before starting this procedure, be sure the power is turned off at the breaker/fuse box. 5. Connect ground (center) wire of power supply cord to the center, silver-colored terminal screw.
- Page 10 Installation instructions Power Supply Cord You will need a 4-wire power supply cord with four No. 10 copper wires and a matching 4-wire receptacle of NEMA Type 14-30R, as illustrated below. The fourth wire must be identifi ed with a white cover and the ground conductor by a green cover.
- Page 11 Customer Care Center 1-800-898-1879 www.askona.com...
- Page 12 We reserve the right to make changes. TD70.1 SPO en (05-16)