Related Manuals for Asko T411HSW
Summary of Contents for Asko T411HSW
- Page 1 INSTALLATION INSTRUCTIONS Heat pump Tumble Dryer DOMESTIC TD85 Carefully read the instructions for use before using the dryer.
-
Page 2: Installation
See also the general Safety Instructions in the Use & Care Guide. Cosmetic damage must be reported to the ASKO dealer within fi ve days from the date of purchase. As soon as you unpack the machine, thoroughly check it for cosmetic damage. - Page 3 The appliance may not be in contact with a wall Freestanding appliance or adjacent furniture. For optimum dryer operation, The dryer may be placed adjacent to a washing observe the clearance from the wall as shown in the machine. fi gure. If the friction between the dryer feet and the fl...
- Page 4 (A+B), supplied in the cardboard box in the dryer drum. Tipping guard part B is designed to fi t on ASKO 100 mm (4") washing machines and it may be hard or impossible to mount on appliances of other brands.
- Page 5 How to stack a dryer onto the washing machine (ASKO): There is a cardboard box in the dryer drum, containing the vacuum feet and the tipping guard. The tipping guard consists of two metal parts (A + Use two screws to attach the A part to the back of the dryer.
-
Page 6: Changing The Door Opening Direction
CHANGING THE DOOR OPENING DIRECTION To change the direction of door opening, proceed as follows. Open the door fully. Undo the screws and remove the door. Use the screwdriver to remove the door lock cover and undo the screw on the door lock. Push the door lock upwards and remove it. - Page 7 Undo the door hinge assembly (left) and the door latch assembly (right), switch their positions, and replace the screws (door hinge assembly to the right- hand side, door latch assembly to the left-hand side). Use the screwdriver to remove the plastic part more easily.
- Page 8 Closet Install- Ventilation Requirements ASKO's front panel controls make it possible to install the washers and dryers in a closet. Make sure there is clearance between units and cabinet or wall and a 1"...
-
Page 9: Draining The Condensate
DRAINING THE CONDENSATE If you decide to run the condensate drain hose The moisture from the laundry is extracted in the into a drain, siphon, or washbasin, make sure the condenser unit and accumulated in the condensate hose is securely fastened. This will prevent any tank. -
Page 10: Electrical Installation
The grounding link on the dryer machine or an equivalent. must be removed for all 4-wire installations. ASKO washers rated 208–240 V have two internal These Electrical Connection instructions provide for fuses of 15 A each. installing the dryer in the following situations:... - Page 11 1. Turn the power off at the breaker or fuse box. Power Supply Cord 2. Remove terminal block cover. You will need a 4-wire power supply cord with 3. Use the strain relief attached below the terminal four No. 10 copper wires and a matching 4-wire block opening.
- Page 12 US.ASKO.COM • CA.ASKO.COM • ASKO.COM/MX We reserve the right to modifi cations. TD85 SPHP DOM US/CA en (12-21)