Integra DRX-4.3 Instruction Manual page 184

of lossy compressed files such as MP3 will be improved. The setting can be set
for each input. This works in signals whose sampling frequencies are 48 kHz or
less. The setting is not effective in the bitstream signals.
• It cannot be set if the listening mode is Direct.
Late Night: Enable small sounds to be easily heard in detail. It is useful when
you need to reduce the volume while watching a movie late night. You can enjoy
the effect only when playing the Dolby series and DTS series input signals.
• This function cannot be used in the following cases.
– When playing Dolby Digital Plus or Dolby TrueHD with "Loudness
Management" set to "Off"
– When the input signal is DTS:X, and "Dialog Control" is not 0 dB
Stereo Assign: When the listening mode is set to "Stereo", the audio output
destination can be set to "Surround", "Surround Back", "Height 1" or "Height 2" in
addition to the normal right and left channels ("Front") of front speakers.
• This function cannot be used if the listening mode is set to modes other than
"Stereo".
• You cannot select speakers that are not set with "2. Speaker" - "Configuration"
on the Setup menu.
Zone B: Select a method of outputting audio to ZONE B from among "Off",
"On(A+B)" and "On(B)".
• In the following cases, "Zone B" cannot be selected.
– When ZONE 2 is On
– When "2. Speaker" - "Configuration" - "Zone 2 Preout" on the Setup menu
is set to "Zone 2" ( p153)
„ AccuEQ
AccuEQ: Enable or disable the equalizer function that corrects for sound
distortion caused by the acoustic environment of the room. To enable this setting,
normally select "On (All Ch)", and to disable only the front speakers, select "On
(ex. L/R)". The setting can be set for each input.
Manual Equalizer: Select "Preset 1" to "Preset 3" configured in "2. Speaker"
- "Equalizer Settings" on the Setup menu. When this is set to "Off", the same
sound field setting is applied to all ranges.
Contents Connections
≫
Re-EQ, Re-EQ(THX):
that it suits a home theater.
The following listening modes can be used for Re-EQ: Dolby Audio - DD, Dolby
Audio - DD+, Dolby Audio - Surr, Dolby Audio - TrueHD, Multichannel, DTS, DTS-
ES, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio, DTS
Neural:X, DTS Express and DSD
In Re-EQ(THX), the following listening modes can be used: THX Cinema and
THX Select Cinema.
• It cannot be set if the listening mode is Direct.
EQ for Standing Wave :
wave generated by the sound wave reflected by wall or similar interfering with the
original sound wave.
„ Level
Front: Adjust the speaker level of the front speakers while listening to the sound.
Center :
Adjust the speaker level of the center speaker while listening to the
sound.
Subwoofer:
Adjust the speaker level of the subwoofer while listening to the
sound.
• If you set the unit to the standby mode, the adjustments you made will be
restored to the previous statuses.
184
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
Adjusts the soundtrack with the enhanced high range so
Setting this "On" will control the effect of the standing
Setup
≫ ≫