Integra DRX-4.3 Instruction Manual page 180

Setting Item Default Value Setting Details
Output Zone Main Select the zone where you want to listen to the
music.
"Main": Outputs audio only to the main room
(where this unit is located).
"Zone 2": Outputs audio only to the separate room
(ZONE 2).
"Main/Zone 2": Outputs audio to both the main
room and separate room.
"Zone 3": Outputs audio only to the separate room
(ZONE 3).
"Main/Zone 3": Outputs audio to both the main
room and separate room (ZONE 3).
"Zone 2/Zone 3": Outputs audio to both the
separate rooms (ZONE 2 and ZONE 3).
"Main/Zone 2/Zone 3": Outputs audio to the main
room and both separate rooms (ZONE 2 and
ZONE 3).
• To use this function, set "Input Selector"
Preset Volume Main: You can set the volume beforehand for playing
Last back the Sonos Connect. You can set volumes
Zone 2: for the main room (where this unit is located) and
Last separate room (ZONE 2 or ZONE 3) respectively.
Zone 3: Select a value from "Last" (Volume level before
Last entering standby mode), "Min", "0.5" to "99.5" and
"Max".
• To use this function, set "Input Selector"
Contents
beforehand.
beforehand.
Connections
≫
7. Multi Zone
„ 1. Zone 2
Change the settings for Zone 2.
Setting Item Default Value
Output Level Fixed
Maximum Volume Off
Power On Volume Last
„ 2. Zone 3
Change the settings for Zone 3.
Setting Item Default Value
Output Level Fixed
180
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select whether to adjust the volume on the premain
amplifier in the separate room or on this unit when
outputting to Zone 2.
"Fixed": Adjust on the pre-main amplifier in the
separate room
"Variable": Adjust on this unit
Set the maximum value for Zone 2 to prevent the
volume from becoming too loud. Select a value
from "Off", and "50" to "99".
(When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Setting Details
Select whether to adjust the volume on the premain
amplifier in the separate room or on this unit when
outputting to Zone 3.
"Fixed": Adjust on the pre-main amplifier in the
separate room
"Variable": Adjust on this unit
• When "2. Speaker" - "Configuration" - "Zone
Speaker" is set to "Zone 2/Zone 3", this setting is
fixed to "Variable".
≫