Integra DRX-4.3 Instruction Manual page 153

Setting Item Default Value Setting Details
Zone Speaker No Set whether speakers are connected to Zone 2 or
Zone 3 speaker terminals.
"Zone 2": When speakers are connected to Zone 2
speaker terminals
"Zone 2/Zone 3": When connecting speaker to both
ZONE 2 speaker terminal and ZONE 3 speaker
terminals.
• This setting cannot be selected under any of
"No": When speakers are not connected to Zone 2
speaker terminals
• This setting cannot be selected when "Zone 2
Zone 2 Preout Zone 2 Set an output destination of the audio output from
ZONE 2 PRE/LINE OUT/ZONE B LINE OUT jack.
"Zone 2": When connecting a pre-main amplifier in
a separate room (ZONE 2)
"Zone B": When connecting a pre-main amplifier,
transmitter of wireless headphones, etc. to ZONE B
• This setting is fixed to "Zone 2" when "Zone
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This setting will be set to "No" in either of
Contents
following conditions.
– When the surround back speakers are used
– When 2 sets of height speakers are used
Preout" is set to "Zone B".
Speaker" is set to "Zone 2" or "Zone 2/Zone 3".
following cases.
– When 2 sets of height speakers are used
– When surround back speakers and height
speakers are being used at the same time.
– When "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3"
Connections
≫
Setting Item Default Value
Speaker 6 ohms or above Set the impedance (Ω) of the connected speakers.
Impedance
153
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
"4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When all the connected
speakers have an impedance of 6 Ω or more
• For impedance, check the indications on the
back of the speakers or their instruction manual.
≫