Integra DRX-4.3 Instruction Manual page 168

Setting Item Default Value Setting Details
USB Power Out Off When this function is set to "On", electricity can be
at Standby supplied to the device connected to the USB port
even if this unit is in standby mode .
• When this function is set to "On", the power
Network Standby On When this function is set to "On", the network
function works even in standby state, and you can
turn on the power of the unit via network using an
application such as Integra Control Pro that can
control this unit.
• When this function is set to "On", the power
• When connection to the network is lost, "Network
Contents
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the Hybrid
Standby mode where only the essential circuits
operate.
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the Hybrid
Standby mode where only the essential circuits
operate. Note that even if this function is set to
"Off", when any of the HDMI CEC ( p163),
p163), USB Power
HDMI Standby Through (
Out at Standby ( p168) and Bluetooth
p168) functions is enabled, this
Wakeup (
function will be in "On" state regardless of the
setting.
Standby" may be disabled to reduce power
consumption. In such a case, turn the unit on by
using the power button on the remote controller
or main unit.
Connections
≫
Setting Item Default Value
Bluetooth Wakeup Off
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be selected. It can
be selected when the network function is activated.
168
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
This function wakes up the unit on standby by
connecting a BLUETOOTH-enabled device.
"On": When this function is used
"Off": When this function is not used
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the Hybrid
Standby mode where only the essential circuits
operate.
• This setting is fixed to "Off" if "Bluetooth" - "Auto
Input Change" is set to "Off".
≫