Integra DRX-4.3 Instruction Manual page 160

„ 3. DTS
Change the setting of when DTS signals are input.
Setting Item Default Value
DTS Auto On
Surround
Dialog Control 0 dB
„ 4. LFE Level
Set the low-frequency effect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
Setting Item Default Value
LFE Level 0 dB
Setting Details
When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker configuration of this unit when playing in
the straight decoding listening mode.
"On": When this function is used
"Off": Audio is played using the same number
of channels in the input signal according to the
speaker configuration of this unit.
• If this function is set to "Off", the ES Matrix and
ES Discrete listening modes cannot be selected.
You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Details
Select the low-frequency effect (LFE) level of each
signal from "0 dB" to "-∞ dB". If the low-frequency
effect sound is too strong, select "-20 dB" or
"-∞ dB".
Contents Connections
≫
„ 5. Volume
Change the Volume settings.
Setting Item Default Value
Volume Display Absolute
Mute Level -∞dB
Maximum Volume Off
Power On Volume Last
Headphone Level 0.0 dB
160
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Switch the volume display between the absolute
value and relative value. The absolute value 82.0 is
equivalent to the relative value 0.0dB.
"Absolute": Absolute value such as "0.5" and "99.5"
"Relative": Relative value such as "-81.5dB" and
"+18.0dB"
• If the absolute value is set to 82.0, "82.0Ref"
appears on the display.
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞dB",
"-40dB" and "-20dB".
Set the maximum value to prevent the volume
from becoming too loud. Select a value from "Off",
and "50" to "99". (When "Volume Display" is set to
"Absolute")
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5"
and "Max". (When "Volume Display" is set to
"Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
≫