Enter Programming Mode
If you will be programming the unit via modem, please refer to the Versa XS online help.
Important: After entering programming mode for the first time, we suggest you change
the password to maintain the security of your system (see page 56).
From the Keypad:
Press
1
Enter the (6) six-digit password. The default is six zeroes.
2
Voice Feedback
The unit is now ready to accept programming instructions!
From the Residence Telephone:
When you lift the receiver, press
1
NOTE: If multiple units are sharing the same phone line, then a Unit ID Code (1-7) will need to be
entered at this time. See page 20 for more information about Multiple Unit Sites.
Enter the (6) six-digit password. The default is six zeroes.
2
Press
and the audio tone will stop.
3
The unit is now ready to accept programming instructions!
From the Remote Telephone:
Dial the unit's phone number:
1
Note: If the unit and an answering machine (or answering service) utilize the same phone line,
let the line ring at least (2) two times, hang-up, and call back within one (1) minute. The unit will
answer on the second call. If the unit does not answer, you may need to change the ring count
(see page 58).
When the unit picks up the call, you will hear the audio message: "Please enter password"
2
Press
3
NOTE: If multiple units are sharing the same phone line, then a Unit ID Code (1-7) will need to be
entered at this time. See page 20 for more information about Multiple Unit Sites.
Enter the (6) six-digit password. The default is six zeroes.
4
Press
and the audio will stop.
5
The unit is now ready to accept programming instructions!
• Press
on the unit keypad and the unit will respond with audio feedback when
disconnecting.
• Press
on the telephone and the unit will respond with audio feedback when disconnecting.
Press
and exit programming mode.
Exit Programming Mode
when using a telephone or the unit to cancel programming sequence
Page 16
***
0