Table of Contents
Advertisement
Set Visitor Talk Time:
This feature sets the amount of time a visitor and resident may talk before the unit breaks
communication. The unit will beep 10 seconds prior to terminating a call. The resident may
press "1" to reset the timer and extend their talk time.
Press
Then
1
Enter Number of Seconds (15-250). Then (#)
2
Enable or Disable "Announce All Doors/Access Granted"
Announce access granted for all doors. If doors are in close proximity know which door to
gain access through. Factory Setting: Disabled.
Press
1
Enable (1) or Disable (0). Then (#)
2
NOTE: Step 23, Enable or Disable "Access Granted" Beeps, controls announcement for door 1
ONLY. Make sure Step 23 is enabled first, before enabling this step.
For EL Model Units with an LCD Display ONLY:
Set Display Greeting:
Press
1
Enter Option:
2
0 - Alternate between Welcome and Instruction Messages.
1 - Show welcome message ONLY.
2 - Show instruction message ONLY.
Return to Menu Programming:
Press
1
Press *** and the 6-Digit Password (2 short beeps will be heard)
Exiting programming mode allows changes to take effect
If you make an error during an entry, press the asterisk key (*) to begin again.
5
Then
160
Then
25
Then
To enter programming mode from the unit
Page 61
Factory Setting: 60 seconds
Example:
Sets the maximum time a visitor can talk
with a resident to "50" seconds.
U G 1 0 , 2 0 0 5
W E L C O M E
* Use Versa XS to modify any
Welcome or Instruction Messages
26
Advertisement
Table of Contents
