Checking The Tire Condition - Husqvarna TC 65 2022 Owner's Manual

13.5

Checking the tire condition

Info
Only mount tires approved and/or recommended by Husqvarna Motorcycles.
Other tires could have a negative effect on handling characteristics.
The type, condition, and pressure of the tires all have a major impact on the handling characteristic of
the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Insert the spacers.
F02176-10
Info
Insert the wide spacer on the left in the direction of
travel.
–
Clean and grease wheel spindle
Long-life grease (
–
Position the rear wheel and insert wheel spindle.
The brake linings are correctly positioned.
–
Mount the chain.
–
Position chain adjuster
spindle in all the way.
E00543-10
–
4
Mount nut
–
Make sure that the chain adjusters are fitted correctly on the
adjusting screws.
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spin-
dle
E00544-10
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
–
Remove the motorcycle from the lift stand. (
WHEELS, TIRES 13
1
and contact
of the spacers.
p. 119)
2
.
p. 119)
3
on both sides and push the wheel
, but do not tighten yet.
p. 63)
.
M14x1.5 40 Nm (29.5 lbf ft)
p. 40)
89