Table of Contents
Advertisement
13.5
Checking the tire condition
Info
Only mount tires approved and/or recommended by Husqvarna Motorcycles.
Other tires could have a negative effect on handling characteristics.
The type, condition, and pressure of the tires all have a major impact on the handling characteristic of
the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position rear wheel and mount the chain.
The brake linings are correctly positioned.
–
Insert wheel spindle
H02528-10
–
Position chain adjuster
it yet.
–
Make sure that chain adjusters
adjusting screws
–
Make sure that the markings on the left and right chain
3
adjusters
B
marks
. The rear wheel is then correctly aligned.
Info
The wide adjustment range of the chain adjusters
enables different secondary ratios with the same chain
length.
Chain adjusters
–
Check the chain tension. (
–
4
Tighten nut
Guideline
Nut, rear wheel spin-
dle
H02529-10
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
–
Remove the motorcycle from the lift stand. (
WHEELS, TIRES 13
p. 127)
2
.
3
4
. Mount nut
3
are fitted correctly on
5
.
are in the same position relative to reference
3
can be turned by 180°.
p. 66)
.
M20x1.5
80 Nm (59 lbf ft)
, but do not tighten
p. 46)
91
Advertisement
Table of Contents
