SERVICE WORK ON THE CHASSIS 11
Main work
–
Shift the transmission into neutral.
–
Check the chain, rear sprocket and engine sprocket for wear.
»
If the chain, rear sprocket or engine sprocket is worn:
–
Change the drivetrain kit.
400227-01
–
Check the engine sprocket cover for wear.
»
If the engine sprocket cover is worn through in the
marked area
–
Change the engine sprocket cover.
–
Check the engine sprocket cover for tightness.
»
If the engine sprocket cover is loose:
–
Tighten the engine sprocket cover.
Guideline
F03073-10
Screw, engine
sprocket cover
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with, or below,
the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
Guideline
Remaining
screws, chassis
F03074-10
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.
When fitting the chain joint, always make sure
that the closed side of the joint faces forward
(direction of travel).
A
:
M6
M6
8 Nm (5.9 lbf ft)
10 Nm (7.4 lbf ft)
65