Lubricating The Steering Head Bearing; Removing The Start Number Plate; Installing The Start Number Plate - Husqvarna TC 65 2022 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.13
11.14
11.15
48

Lubricating the steering head bearing

H02387-01

Removing the start number plate

F02922-10

Installing the start number plate

F02924-10
Guideline
Screw, steering stem M8
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
Position the fuel tank breather
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
–
1
Remove screw .
–
Unhook the start number plate from the brake line and
remove it.
–
Attach the start number plate to the brake line.
–
Position the start number plate.
1
Holding lugs engage in the fender.
20 Nm (14.8 lbf ft)
M8 20 Nm (14.8 lbf ft)
1
in the steering stem.
p. 47)
p. 40)
( p. 44)
( p. 45)