Husqvarna TC 65 2022 Owner's Manual page 86

12 BRAKE SYSTEM
84
–
Remove screws
–
Take off cover
–
Press the brake piston back to its basic position and make
sure that no brake fluid overflows from the brake fluid reser-
voir, extract brake fluid if necessary.
–
Position the brake caliper.
–
Mount and tighten screw
Guideline
F02256-10
Screw, rear
brake caliper
–
Mount and tighten screw
Guideline
Screw, rear
brake caliper
Warning
Danger of accidents Oil or grease on the brake
discs reduces the braking effect.
–
Always keep the brake discs free of oil and
grease.
–
Clean the brake discs with brake cleaner when
necessary.
E00550-11
Warning
Danger of accidents Brake linings which have not
been approved alter the braking efficiency.
Not all brake linings are tested and approved for
Husqvarna motorcycles. The structure and friction
coefficient of the brake linings, and thus their brake
power, may vary greatly from that of original brake
linings.
If brake linings are used that differ from the original
equipment, compliance with the original homologa-
tion is not guaranteed. In this case, the vehicle no
longer corresponds to its condition at delivery and
the manufacturer warranty shall be void.
–
Only use brake linings approved and
recommended by Husqvarna motorcycles.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned
in the holding spring.
5
.
6 7
with washer and membrane
4
.
M8x20 18 Nm (13.3 lbf ft)
3
.
M8x40 18 Nm (13.3 lbf ft)
8
.
®
Loctite 243™
®
Loctite 243™