Power Up The Node; Verify The Operation Of A Replacement I/O Module; Return A Faulted Part; Replace A Fan Module - Dell PowerStore 1000 Installation And Service Manual

Table of Contents

Advertisement

● If the button remains in, the module is fully seated.
● If the button springs back, gently push the module further into the chassis, then push it again.
● If the button still does not rest flush with its handle, remove the module and repeat steps 1 and 2.
Figure 90. Locking in the I/O module
3. Connect the cables into the assigned I/O module ports.

Power up the node

Power up the node as described in

Verify the operation of a replacement I/O module

Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the I/O module.
3. On the Components card, under Rear View, expand BaseEnclosure.
4. Expand the node that includes the I/O module, and then select the relevant IoModule.
The status of the replacement I/O module should read Healthy. If the status is still Faulted, wait a few minutes and
refresh PowerStore Manager. If the status does not change, ensure that the I/O module is correctly seated, or contact your
service provider.

Return a faulted part

About this task
For US customers, return defective material within five business days. For International customers, return defective material
within 10 business days. The materials required to return your defective part are supplied with the good part shipment.
Steps
1. Package the faulted part in the shipping box that contained the replacement part.
2. Ship the failed part to your service provider as described in the instructions that were included with the replacement part.
3. For more information about returning customer-replaceable parts:
a. Open PowerStore Manager.
b. Click Settings on the upper right of the screen.
c. Click General Support.
d. Under Drives, Power Supplies, and Other Parts, click Return Part.
e. If your screen does not show the Return Part link, contact your service provider for instructions.

Replace a fan module

Take the following actions to remove the faulted fan module and install the replacement fan module into the system.
Power control
procedures.
Base enclosure service procedures
85

Advertisement

Table of Contents
loading

Table of Contents