Table of Contents
Advertisement
Figure 152. Installing a drive
The activity light flashes to indicate that the spin-up sequence has begun.
Installing the front bezel
Steps
1. Align the bezel with the enclosure.
2. Gently push the bezel into place on the cabinet until it latches.
3. If the bezel has a key lock, lock the bezel with the provided key.
Figure 153. Installing the bezel
Verify the operation of an added drive
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you added the drive.
3. On the Components card, under Drives, expand ExpansionEnclosure and select the drive.
The status of the drive should read Healthy. If the status is still Faulted, wait a few minutes and refresh PowerStore
Manager. If the status does not change, ensure that the drive is correctly seated, or contact your service provider.
126
SAS expansion enclosure service procedures
CL5262
Advertisement
Table of Contents
