Table of Contents
Advertisement
2. Align the white pegs beneath the holes on the 4-port card.
CAUTION:
Do not force the 4-port card into place. If the 4-port card does not smoothly seat, re-align the
pegs and try again.
Figure 62. Seating the 4-port card
3. Gently push down on the upper-left circle on the 4-port card.
4. Push up on the blue tabs until they lock into place.
Figure 63. Locking the 4-port card into position
5. Replace both air dams and tighten the captive screws.
6. Install the SFPs into the embedded module.
Install an embedded module
Steps
1. Align the embedded module with the empty slot and carefully push it into the slot.
As the embedded module is installed, the release lever rotates inward.
66
Base enclosure service procedures
Advertisement
Table of Contents
