Installing The Front Bezel - Dell EMC Unity All Flash Installation And Service Manual

DPE front status LEDs
Figure 8. DPE and drive LEDs
Table 2. DPE and drive LEDs
LED
Drive fault
Drive active
DPE fault/power

Installing the front bezel

About this task
CAUTION: Remove the plastic protective strip from the front of the bezel prior to placing the system into
operation. Failure to do so will cause the system to overheat.
Steps
1. If present, remove the plastic protective strip from the front of the bezel.
2. Align the bezel with the enclosure.
3. Gently push the bezel into place on the cabinet until it latches.
4. If the bezel has a lock, insert the key that shipped with your enclosure into the lock, and turn the key to lock the bezel.
16 Installation Procedures
Location State
Amber
Off
Blue
Off
Blue
Amber
Off
Description
Fault has occurred.
No fault has occurred, normal operation.
Drive activity.
Drive is powered off.
Power is on. No fault has occurred, normal
operation.
Power is on. Fault has occurred within the
enclosure.
Power is off.