Removing The Expansion Card Riser - Dell E33S001 Owner's Manual

Card priority
9
10
11
12
13
14
15
16

Removing the expansion card riser

Prerequisites
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect the PERC card LED cable.
NOTE: This step is applicable only to the cabled hard drive systems.
Steps
1 Lift and rotate the expansion card riser latch to open it.
2 Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Card type
1 Gb NIC (Broadcom quad
port)
1 Gb NIC (Broadcom low
profile)
1 Gb NIC (Intel dual port)
1 Gb NIC (Intel dual port,
low profile)
1 Gb NIC (Broadcom dual
port)
1 Gb NIC (Broadcom dual
port, low profile)
12 Gb SAS (full height)
12 Gb SAS (low profile)
Slot priority
2
1
2
1
2
1
2
1
Maximum allowed
1
1
1
1
1
1
1
1
Installing and removing system components 95