2. Install the
heat
sink.
3. Install the
base
cover.
4. Install the
SIM card
tray.
5. Install the
SD
card.
6. Follow the procedure in
Power button with fingerprint reader assembly
Removing the power button with fingerprint reader assembly
Prerequisites
NOTE:
For system shipped with power button with fingerprint reader assembly only.
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
heat
sink.
6. Remove the
display
assembly.
7. Remove the
I/O daughter
About this task
The following images indicate the location of the power-button and provide a visual representation of the removal procedure.
Steps
1. Gently disconnect the power button with fingerprint reader FPC cable from the connector on the USH daughter board.
52
Removing and installing components
After working inside your
Before working inside your
tray.
board.
computer.
computer.
Before working inside your