Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Base cover
Solid-state drive
WWAN card
System fan
Heat sink
Display assembly
Battery
Left speaker
10
Removing and installing components
Screw type
Captive screws
M1.6x2.5
Captive screw - (M2x3)
M1.6x2.5
Captive screws
M2.5x3
M1.6x3
M2x4
M1.6x1.8
Quantity
8
1
1
2
3
6
1
4
1
2
Image
N/A