Steps
1. Align and place the WLAN antenna module in the slot on the system.
2. Replace the two (M1.6x3) screws that secure the WLAN antenna module to the palm-rest assembly.
3. Connect the WLAN antenna module's Proximity sensor cable to the RF board and route the Proximity sensor cable in the
routing guides.
4. Align and place the Proximity sensor bracket on the RF board.
5. Replace the single (M1.6x1.8) screw securing the Proximity sensor bracket to the palm-rest assembly.
Next steps
1. Install the battery.
2. Install the
WWAN
card.
3. Install the
base
cover.
4. Install the
SIM card
tray.
5. Install the
SD
card.
6. Follow the procedure in
I/O daughter board
Removing the I/O daughter board
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
heat
sink.
6. Remove the
display
assembly.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
tray.
computer.
computer.
Before working inside your
Removing and installing components
49