Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. Tighten the three captive screws that secure the heat sink to the system board.
3. Adhere the heat absorber for the DDR5 onboard memory on the heat-sink.
4. Replace the heat shield cover.
Next steps
1. Install the
base
cover.
2. Install the
SIM card
tray.
3. Install the
SD
card.
4. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
NOTE:
The display assembly removal procedure is the same for both laptop and 2-in-1 chassis.
After working inside your
Before working inside your
tray.
computer.
computer.
Before working inside your
Removing and installing components
33