Troubleshooting; Side Burner Troubleshooting; Grill Out Handle Light Troubleshooting - Weber Sumnnit E-420 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas. (This is normal for
the burner lighting tube.)
Symptoms:
Burner does not light, or flame is low in HI position.
Experiencing flare-ups:
m CAUTION: Do not line the slide-out
grease tray with aluminum foil.
Burner flame pattern is erratic. Flame is low when
burner is on HI. Flames do not run the whole length
of the burner tube.
Inside of lid appears to be "peeling." (Resembles
paint peeling.)
Cabinet doors are not aligned.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com.
PROBLEM
Side burner does not light.
Flame is low in HI position.
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com.
PROBLEM
Weber
Grill Out™ Handle Light does not light.
®
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com.

TROUBLESHOOTING

Inspect spider/insect screens for possible obstructions .
(Blockage of holes .)
Is fuel hose bent or kinked?
Does burner light with a match?
Did you use the snap igniter several times until the main
burner lit (refer to "MAIN BURNER IGNITION")?
Does the igniter work? Do you see a spark when you
repeatedly use the snap igniter?
Are you preheating grill in the prescribed manner?
Are the cooking grates and Flavorizer
coated with burned-on grease?
Is the slide-out grease tray "dirty" and not allowing
grease to flow into catch pan?
Are burners clean?
The lid is porcelain enamel or stainless steel, not paint .
It cannot "peel . " What you are seeing is baked-on grease
that has turned to carbon and is flaking off .
THIS IS NOT A DEFECT.
Check the adjustment pin on the bottom of each door .

SIDE BURNER TROUBLESHOOTING

Is gas supply off?
Is the fuel hose bent or kinked?
Does burner light with a match?
GRILL OUT
HANDLE LIGHT TROUBLESHOOTING
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber
Grill Out™ Handle Light activated?
®
Is the Weber
Grill Out™ Handle Light positioned
®
correctly on the handle?
CHECK
Clean spider/insect screens (refer to "ANNUAL
MAINTENANCE") .
Straighten fuel hose .
Clean burners (refer to "MAINTENANCE") .
Make sure to hold the control knob in for two seconds
after snapping the igniter and seeing the orange flame
from the burner lighting tube .
Try manually lighting the burner (refer to "MAIN BURNER
MANUAL IGNITION") . Call Customer Service .
All burners on HI for 10 to 15 minutes for preheating .
®
bars heavily
Clean thoroughly (refer to "CLEANING") .
Clean slide-out grease tray .
Clean burners (refer to "MAINTENANCE") .
Clean thoroughly (refer to "CLEANING") .
Loosen adjustment nut/s . Slide door/s until aligned .
Tighten nut/s .
CHECK
Turn supply on .
Straighten hose .
If match lights burner, check igniter . Refer to "SIDE
BURNER MAINTENANCE" .
CHECK
Replace batteries .
Refer to assembly illustration .
Light will activate when lid is open .
Press the power button .
Adjust position . Refer to assembly illustration .
SOLUTION
SOLUTION
SOLUTION
WWW.WEBER.COM
®
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sumnnit s-420

Table of Contents