Table of Contents
Advertisement
Y
OU MUST READ THIS
BEFORE OPERATING YOUR GAS GRILL
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flames.
3. Open lid
4. If odor continues, keep away from the
appliance and immediately call your gas
supplier or your fire department.
Leaking gas may cause a fire or explosion
which can cause serious bodily injury or
death, or damage to property.
WARNING
1. Do not store spare liquid propane
cylinder within 10 feet (3m) of this
appliance.
2. Do not store or use gasoline or other
flammable liquids or vapors within 25
feet (8m) of this appliance.
WARNING: Follow all leak-check
procedures carefully in this manual prior to
barbecue operation. Do this even if the
barbecue was dealer-assembled.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
WARNING: Do not try to light this
appliance without reading the "Lighting"
Instructions section of this manual
S U M M I T
Natural Gas Grill Owners Guide
O
G
WNERS
UIDE
DANGER
®
#
A405_NG.d
Ba402_NG.a
B405_NG.c
C405_NG.c
D405_NG.d
E403.b
&
43721
43721 US 01/29/03
NG
Advertisement
Chapters
Table of Contents
Troubleshooting
Related Manuals for Weber Summit Gold B NG
Summary of Contents for Weber Summit Gold B NG
- Page 1 & ® S U M M I T Natural Gas Grill Owners Guide OU MUST READ THIS WNERS UIDE 43721 BEFORE OPERATING YOUR GAS GRILL DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3.
- Page 2 Should the burners go out while in operation, turn all gas valves off. Open the lid and wait five minutes before attempting to relight, using the lighting instructions. Do not use charcoal or lava rock in your Weber ® gas barbecue.
-
Page 3: Table Of Contents
Contents Danger & Warnings ..................A-2 Warranty ....................A-4 General Instructions .................A-5 Grilling Methods ..................A-6 Cleaning ....................A-6 Exploded View ..................A-7 Parts List ....................A-11 Assembly Instructions ................B-a Gas Instructions ..................C-1 Leak Checking ..................C-4 Operating ....................D-1 Grilling Methods ..................D-1 Lighting ....................D-3 Manual Lighting ..................D-4 Lighting the Side Burner ................D-5 Troubleshooting... -
Page 4: Warranty
WEBER-STEPHEN PRODUCTS CO. printed instructions accompanying it. Customer Service Center Weber may require reasonable proof of your date of 1890 Roselle Road, Suite 308 purchase. THEREFORE, YOU SHOULD RETAIN YOUR Schaumburg, IL 60195 SALES SLIP OR INVOICE. -
Page 5: General Instructions
Portability using. (See Sections: “General Maintenance and ® means you can take your Weber gas barbecue with you if Annual Maintenance.”) you move. -
Page 6: Grilling Methods
NOTE: If grill looses heat while cooking refer to the WARNING: Turn your Weber gas barbecue OFF and troubleshooting section of this manual. wait for it to cool before cleaning. WARNING: Do not move the Weber ® gas barbecue CAUTION: Do not clean your Flavorizer ®... -
Page 7: Exploded View
® Summit Silver B Exploded View Summit ® Silver B NG 012903... -
Page 8: Cookbox
® Summit Silver B Exploded View List 1. Hinge Pin 39. Hair Pin Cotter 2. Thermometer Hardware 40. Lid Assembly 3. Thermometer Bezel 41. 1/4 - 20 x 1 1/4 inch Bolt 4. Warm-Up ™ Basket 42. Right Flavorizer ® Bar Assembly 5. - Page 9 Summit ® Gold B Exploded View Summit Gold B NG 012903 ®...
-
Page 10: Rear Panel
® Summit Gold B Exploded View List 1. Hinge Pin 40. Hair Pin Cotter 2. Thermometer Hardware 41. Lid Assembly 3. Thermometer Bezel 42. 1/4 - 20 x 1 1/4 inch Bolt ™ 4. Warm-Up Basket 43. Right Flavorizer Bar Assembly 5. - Page 11 ® Summit Silver B Parts List Lid - 1 Bottom Shelf - 1 Left Door - 1 Cookbox - 1 Right Door - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Side Table - 1 Left Frame Side Burner - 1 Assembly - 1 Right Frame Assembly - 1...
- Page 12 ® Summit Silver B Parts List ® Flavorizor Bars - 2 Sets Hinge Pin- 2 Hair Pin Cotter- 2 1-1/4 inch Bolts (1/4 x 20 x 1-1/4 inch Bolt) - 2 Stainless Steel Nut Hex (1/4 x 20 Blk Zinc) - 2 Cooking Grates - 2 1/2 inch Bolts (1/4 x 20 x 1/2 inch Bolt) - 8...
- Page 13 ® Summit Gold B Parts List Lid - 1 Bottom Shelf - 1 Left Door - 1 Cookbox - 1 Right Door - 1 Front Frame Rail - 1 Rear Frame Rail - 1 Side Table - 1 Side Burner - 1 Left Frame Assembly - 1 Right Frame Assembly - 1...
- Page 14 ® Summit Gold B Parts List ® Flavorizor Bars - 2 Sets Hinge Pin- 2 Hair Pin Cotter- 2 1-1/4 inch Bolts (1/4 x 20 x 1-1/4 inch Bolt) - 2 Stainless Steel Nut Hex (1/4 x 20 Blk Zinc) - 2 Cooking Grates - 3 1/2 inch Bolts (1/4 x 20 x 1/2 inch Bolt) - 8...
- Page 15 Place corregated from each side of the Cookbox under the Caster and Wheel Frame Assembly to level the frames for Frame Rail Assembly. CAUTION: Before proceeding to the next step check that frame rail (2) is on the side with the swing tables (3).
- Page 16 ATTENTION! Only start these bolts. Do not tighten yet.
- Page 18 ATTENTION! Completely remove both partially started bolts from top rear frame rail ATTENTION! Reinstall both bolts through rear panel and into rear frame rail.
- Page 19 ATTENTION! Remove packing tape holding the gas line and bracket(1). When installing cookbox route the gas line and bracket(1) inside the frame rails(2).
- Page 22 Matchlight Holder...
- Page 25 NOTE: Igniter Wire(1) is located up under right side of control panel. B405_NG.c...
- Page 26 CAUTION: Hold burner cap(1) down while pushing side burner ignition wire(2) on.
-
Page 31: Gas Instructions
If they do not turn, This is a typical installation they are off. Proceed to the next step. If they do turn of a Weber ® natural gas continue turning them clockwise until they stop, then they barbecue. -
Page 32: Leak Checking
Gas Instructions Check for Gas Leaks Connect Gas Supply DANGER Do not use an open flame to check for gas leaks. Be a) To connect gas hose at the supply: Slide back the sure there are no sparks or open flames in the area collar of the quick disconnect. - Page 33 Gas Instructions ® WARNING : The gas connections of your Summit Put your fingers under the front edge of the control panel gas grill have been factory tested. We do however and lift off. recommend that you leak check all gas connections before operating your Summit ®...
- Page 34 Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame- tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber ® barbecue. Shipping and handling may loosen or damage a gas fitting.
-
Page 35: Wrench
Gas Instructions Check: 1) Quick disconnect hose to grill connection WARNING: If there is a leak at connection (6), 2) Side burner hose to manifold connection retighten the fitting with a wrench and recheck for 3) Side burner hose to side burner connection leaks with soap and water solution. - Page 36 Gas Instructions Reinstall control panel Parts required: control panel, screws, and burner control knobs. Place the control panel back onto the control panel brackets on either side of the front of the cooking box. Line up screws with screw holes on both the control panel and control panel brackets.
-
Page 37: Operating
Operating Instructions Grilling Methods Direct cooking The Direct Method, similar to broiling, means the food is cooked directly over the heat source. For even cooking, NOTE: If grill looses heat while cooking refer to the food should be turned once halfway through the grilling troubleshooting section of this manual. -
Page 38: Operating Instructions
Operating Instructions Grilling Tips & Helpful Hints Indirect cooking The Indirect Method is similar to roasting, but with the • Always preheat the grill before cooking. Set all burners added benefits of that grilled texture, flavor, and on HIGH heat and close lid; heat for 10 minutes, or until appearance you can’t get from an oven. -
Page 39: Lighting
*The grill illustrated may have slight differences than the the hose is found to be damaged in any way, do not model purchased. ® use the barbecue. Replace using only Weber authorized replacement hose. Contact the Customer Service Representative in your region 1) Open the lid. -
Page 40: Manual Lighting
Operating Instructions Manual Lighting DANGER Failure to open lid while igniting the 4,5,7 barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death. -
Page 41: Lighting The Side Burner
Operating Instructions Lighting the side burner if the main burners are lit. Side Burner Lighting Instructions 1) Open the side burner lid. 2) Push down and turn the side burner control to START/ DANGER 3) Push igniter button and hold until burner ignites. You will Failure to open the lid while igniting the side hear the igniter sparking burner, or not waiting 5 minutes to allow the... -
Page 42: Cooking Grates
Main Burner Troubleshooting Problem Check Cure Burners burn with a yellow or Inspect Weber ® Insect/Spider Clean Weber ® Insect/Spider orange flame, in conjunction with Screens for possible obstructions. Screens. (See Section “Annual the smell of gas. (Blockage of holes.) Maintenance”) -
Page 43: Hose
Side Burner Troubleshooting Problem Check Cure Side Burner does not light. Is gas supply off? Turn supply on. Flame is low in HIGH position. Is the fuel hose bent or kinked? Straighten hose. Push button ignition does not Does burner light with a match? If match lights burner, checkigniter (see below). -
Page 44: Maintenance
If the spider/insect screen becomes damaged or cannot be can nest in the venturi section(1) of the burner tubes. This cleaned, call Weber-Stephen Products Customer Service blocks the normal gas flow, and can cause the gas to flow for replacement parts. -
Page 45: Replacing Main Burners
Maintenance Replacing Main Burners ® Your Summit gas grill must be OFF and cool. Turn gas OFF at source. Disconnect regulator. Remove cooking grates. Remove Smoker box. ® Remove Flavorizer bars. To remove control panel refer to “Remove the control panel” under “Check for Gas Leaks.” Disconnect all ignition wires from the Ignition Module. - Page 46 Maintenance Remove screws from the manifold assembly: Pull manifold assembly out from the manifold frame. (a) Locate the screws on both sides of the manifold frame. (b) Remove the screws from manifold frame.
- Page 47 Maintenance Lift and twist the burner assembly slightly, to separate To reinstall the manifold assembly, reverse steps 7 ® the Crossover tube (a) from the burners (b). through 13. CAUTION: The burner openings (1) must be positioned properly over the valve orifices (2).
-
Page 48: Crossover Ignition System Operations
Maintenance Crossover ® Ignition System Operations If the Crossover ® ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover ®...