Programming The Memory Feature; Linking And Unlinking The Key Fob To Memory - Jeep GRAND CHEROKEE L 2023 Owner's Manual

Passenger's Side (If Equipped)
Seat Position

The memory settings switches are located on the
front door panels, next to the door handle, and
consists of three buttons:
The set (S) button, which is used to activate the

memory save function.
The (1) and (2) buttons which are used to recall

either of two saved memory profiles.
Memory Setting Buttons
NOTE:
Your vehicle is equipped with two key fobs, each

can be linked to either driver's side memory
position 1 or 2.
Front passenger memory settings cannot be

linked to a key fob.
P T M
ROGRAMMING HE EMORY
To create a new memory profile, perform the
following:
NOTE:
Saving a new memory profile will erase the
selected profile from memory.
1. Place the vehicle's ignition in the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt/
telescopic steering column [if equipped], and
radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release either of
the memory buttons (1) or (2). The instrument
cluster display will indicate which memory
position has been set.
NOTE:
Memory profiles can be set without the vehicle in
PARK, but the vehicle must be below 5 mph
(8 km/h) to recall a memory profile.
GETTING TO KNOW YOUR VEHICLE
F L A U
EATURE INKING ND
T M
O EMORY
Your key fobs can be programmed to recall one of
two saved driver's side memory profiles.
NOTE:
Before programming your key fobs you must select
the "Personal Settings Linked To Key Fob" feature
through the Uconnect Settings Ú page 204.
To program your key fobs, perform the following:
1. Place the vehicle's ignition in the OFF
position.
2. Select a desired driver's side memory profile,
1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory
switch.
4. Within five seconds, push and release button
(1) or (2) accordingly. "Memory Profile Set"
(1 or 2) will display in the instrument cluster.
5. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Your key fobs can be unlinked from your driver's
side memory settings by pushing the set (S) button,
and within 10 seconds, pushing the unlock button
on the key fob.
35
T K F
NLINKING HE EY OB
2