Programming The Memory Feature; Linking And Unlinking The Key Fob To Memory; Memory Position Recall - Jeep CHEROKEE 2023 Owner's Manual

NOTE:
 Your vehicle is equipped with two key fobs, each can be
linked to either memory position 1 or 2.
 Be sure to program the radio presets prior to program-
ming the memory settings.
The memory settings switch is located on the driver's door
trim panel. The switch consists of three buttons:
 The set (S) button, which is used to activate the
memory save function.
 The (1) and (2) buttons which are used to recall either
of two saved memory profiles.
Driver Memory Switch
P T M
ROGRAMMING HE EMORY
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected profile
from memory.
1. Place the vehicle's ignition in the ON/RUN position.
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror and radio station
presets).
3. Push the set (S) button on the memory switch, and
then push the desired memory button (1 or 2) within
five seconds. The instrument cluster display will show
which memory position is being set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory profile.
L A U T
INKING ND NLINKING
T M
O EMORY
Your remote keyless entry key fob can be programmed to
recall one of two saved memory profiles.
NOTE:
Before programming your key fob you must select the
"Personal Settings Linked to Key Fob" feature through the
Uconnect system Ú page 126.
GETTING TO KNOW YOUR VEHICLE
F
To program your key fob, perform the following:
EATURE
1. Place the vehicle's ignition in the OFF position.
2. Select the desired memory profile 1 or 2.
3. Push and release the set (S) button on the memory
switch, then within five seconds push and release the
button (1) or (2) accordingly. "Memory Profile Set"
(1 or 2) will display in the instrument cluster display.
4. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory settings
by pushing the set (S) button, followed by pushing the
unlock button on the key fob within 10 seconds.
M P
EMORY
NOTE:
If a recall is attempted when the vehicle is not in PARK, a
K F
message will display in the instrument cluster display.
HE EY OB
To recall the memory settings for driver one or two, push
the desired memory button number (1 or 2) or the unlock
button on the key fob linked to the desired memory
position.
A recall can be canceled by pushing any of the memory
buttons (S, 1, or 2) during a recall. When a recall is
canceled, the driver seat will stop moving. A delay of one
second will occur before another recall can be selected.
27
R
OSITION ECALL
2