Jeep GRAND CHEROKEE L 2023 Owner's Manual page 200

198 STARTING AND OPERATING
If the vehicle is equipped with Quadra-Lift

air suspension, the engine should be
started and left running for a minimum of
60 seconds (with all the doors closed) at
least once every 24 hours. This process
allows the air suspension to adjust the
vehicle's ride height to compensate for
temperature effects.
Engaging/disengaging of the Electric Park

Brake requires the ignition to be in the ON/
RUN position.
If shift conditions/interlocks are not met, a

"4WD Shift Canceled" or a "4WD Shift
Aborted/ Retry Shift" message will be
displayed on the instrument cluster. To reat-
tempt shift, put the transmission in
NEUTRAL (N) and push and hold the 4WD
LOW button.
If shift conditions/interlocks are not met, a

"To Complete 4WD Shift Put Transmission
In Neutral" or a "To Complete 4WD Shift
Speed Must Be Below 3 MPH" or a "To
Complete 4WD Shift Allow Engine To Return
To Idle" message will flash from the instru-
ment cluster display Ú page 98.
5. Using a ballpoint pen or similar object, push
and hold the recessed transfer case N
(NEUTRAL) button (located by the selector
switch) for more than four seconds. The light
behind the N symbol will blink, indicating shift
in progress. The light will stop blinking (stay on
solid) when the shift to N (NEUTRAL) is
complete. A "Four Wheel Drive System In
Neutral" message will appear in the
instrument cluster.
N (NEUTRAL) Button
6. After the shift is complete and the N
(NEUTRAL) light stays on, release the N
(NEUTRAL) button.
7. Shift the transmission into REVERSE or DRIVE.
8. Release the brake pedal for five seconds and
ensure that there is no vehicle movement.
9. Press and hold the brake pedal. Shift the
transmission back into NEUTRAL.
10. Apply the Electric Park Brake.
11. With the transmission and transfer case in N
(NEUTRAL), push and hold the ENGINE START/
STOP button until the engine turns off. Ensure
vehicle is in RUN position with the engine off.
12. Place the transmission gear selector in PARK.
Release the brake pedal.
13. Attach the vehicle to the tow vehicle using a
suitable tow bar.
14. Release the Electric Park Brake. Ensure
vehicle is in RUN position with the engine off.
15. Push the ENGINE START/STOP button twice
(without pressing the brake pedal), to turn the
ignition to the OFF position.
Shifting Out Of Transfer Case N (NEUTRAL)
Use the following procedure to prepare your
vehicle for normal use:
1. Bring the vehicle to a complete stop, leaving
it connected to the tow vehicle.
2. Apply the Electric Park Brake.
3. Start the engine or for 4xe vehicles ensure the
vehicle is in Ready to Drive mode, the READY
indicator will appear in the instrument cluster
display.