Communicating With Other Station; Disconnecting From The Node Or Room; Closing The Wires-X Software - Yaesu WIRES-X FT3D Instruction Manual

③ Connecting to the node or room you have most recently connected
1. If you have previously connected to a node ID or a room ID on the Internet, it
appears and flashes on the LCD.
• Press the [BAND] (MHz) key to start connection, and once connection is es-
tablished, the menu list of the node (room) you are connected to will appear.
• If connection is unsuccessful, an error message appears and the name flash-
es again.
④ Entering the DTMF ID number (5 digits) of the node or the room
1. Press and hold the [#] key on the microphone.
Displays the DTMF ID input screen.
2. Enter the 5-digit DTMF ID.
3. Press the [#] key on the microphone to start a connection.
• Once connection is successfully established, "Connected" will appear on the LCD.
• If connection is unsuccessful, an error message appears and the screen returns to the DTMF ID input screen.
• Press the [


Communicating with other station

1. Press the PTT switch on the transceiver of the portable node to communicate with the other station.
• In the Access Point, the signal is relayed to the Internet station and also transmitted from the C4FM digital radio
at the same time.
• In the Direct Operation, the signal will only be relayed to the other station on the Internet. The TX/BUSY LED
lights red but the transceiver does not transmit radio waves, so the PO meter does not swing.
2. Release the PTT switch to return to receive mode.
• In the Access Point operation, the voice from the other station on the Internet sounds from the speaker, and
at the same time the C4FM digital signal is transmitted. Also, the voice from another C4FM digital transceiver
accessing the portable node will sound on the speaker, and at the same time it will be relayed to the other station
on the Internet.
• In the Direct Operation, the TX/BUSY LED lights green while receiving communication from the other station on
the Internet, but the S meter does not swing.
• In the Access Point operation, when setting a
to the same number. A node that is set to a different number will not work properly.
• When setting the receive DG-ID number to "00" and setting the transmit DG-ID number to anything other than "00", the
voice of all received C4FM digital stations will be heard on the speaker, but for the transmit DG-ID Only the matched
communication is relayed to the opposite station on the Internet.

Disconnecting from the node or room

To disconnect a connected Internet node or room, use the transceiver below or select [Disconnect] from the [Connect]
menu of the WIRES-X software.
FT3D or FT2D: Press and hold the [BAND] key.
FTM-400XD/D, FTM-300D or FTM-100D: Press and hold the [

Closing the WIRES-X software

1. From the "File" menu, select "Exit"
If "Enable WIRES-X Auto Start." has been selected when
installing the WIRES-X software, the software will restart
immediately after closing the software.
If you do not want to restart the software, click the
WIRES-X icon on the right part of the Windows task bar (or
from the hidden indicator list), then select "Quit" or "Auto
Start" to remove the check mark.
] key on the microphone to cancel the DTMF input screen.
receive
DG-ID number (except for "00"), set the
] key on the microphone.

44
transmit
DG-ID number