Connect To The Hri-200 Node Station - Yaesu DR-1X FR Operating Manual

12. Connect to the HRI-200 node station

To use WIRES-X with DR-1X, connect HRI-200 directly to the 10-pin plug on the back of the DR-1X.
Alternatively, there is a method the HRI-200 Node station may be located in a place different from the repeater
site.
Since the repeater site does not normally have a large capacity Internet line, and the HRI-200 must always be
connected to the computer, it may be advantageous to set up the HRI-200 in a different location and uplink it
to the repeater with the Node Station transceiver. It is recommended to downlink and connect to WIRES-X.
For HRI-200 and WIRES-X, please refer to their respective instruction manuals.
RF Link
Link the DR-1X and the node station with the uplink and downlink signals using the DG-ID, WIRES-X may be
operated using the repeater.
Example using the DG-ID "01":
When the DR-1X and the node station transceiver are set to DG-ID "01", the downlink signal of the DR-1X is
received only by the node stations with the DG-ID set to "01". The repeater connects to the Internet when a
signal containing the DG-ID "01" is received on the uplink.
DR-1X
WIRES-X Node Station
Local node
PC
HRI-200
Internet
Setting method
1 Set the DR-1X repeater DG-ID to "01" (see page 14).
2 Set the node station transceiver DG-ID to "01" for both transmit and receive.
For instructions on setting the DG-ID, refer to the transceiver Operating Manual.
3 Set the WIRES-X node station transmit frequency to the uplink frequency of the DR-1X repeater.
4 Set the WIRES-X node station receive frequency to the downlink frequency of the DR-1X repeater.
When the DR-1X repeater is connected to a Node Station with the DG-ID "01", it downlinks only WIRES-X
signals that include the DG-ID "01". Communications via the WIRES-X node and the DR-1X repeater are
commenced.
30